What is a Filter Circuit ?

Generally, a rectifier is required to produce pure d.c. supply for using at various places in the electronic circuits. However, the output of a rectifier has pulsating character i.e. it contains a.c. and d.c. components. The a.c. component is undesirable and must be kept away from the load.  To do so, a filter circuit is used which removes (or filters out) the a.c. component and allows only the d.c. component to reach the load.

A filter circuit is a device which removes the a.c. component of rectifier output but allows the d.c. component to reach the load.

Filter Circuit

Obviously, a filter circuit should be installed between the rectifier and the load as shown in Fig. A filter circuit is generally a combination of inductors (L) and capacitors (C). The filtering action of L and C depends upon the basic electrical principles.  A capacitor passes a.c. readily but does not pass d.c. at all.

On the other hand, an inductor opposes a.c. but allows d.c. to pass through it.  It then becomes clear that suitable network of L and C can effectively remove the a.c. component, allowing the d.c. component to reach the load.

Types of Filter Circuits

The most commonly used filter circuits are

  1. capacitor filter,
  2. choke input filter and
  3. capacitor input filter or π-filter.

 

You May Also Like :

Half Wave Rectifier Working Animation

Half Wave Rectifier Principle

Half-Wave Rectifier Operation The below Figure illustrates the process called half-wave rectification. A diode is connected to an ac source and to a load resistor, RL, ...